How to Reinstall Print Head on HP Officejet Pro 8610 Printer? [Solution]

Sometimes printer users got a problem on the Print Head, especially users of HP Officejet Pro 8610 printer. For this case, the users of this printer need to know 'How to Reinstall Print Head on HP Officejet Pro 8610 Printer'. In this article, we will give to you a solution to fix this problem.

If you got problem on your Print Head, Reinstall Print Head Only perform this procedure, if a missing or defective Print Header message has been emitted and the printer was first turned Off, then turned ON to try to resolve the message. If the message persists, try this procedure:

To reinstall the print head, follow this steps:

(1) Make sure the HP Officejet Pro 8610 printer is turned ON.

(2) Open the access door of the print cartridge.


(3) Lift the latch on the print carriage.


(4) Remove the print head by lifting it slightly up and out of the printer.


(5) Make sure the latch is lifted, and then reinsert the print head.

(6) Carefully lower the latch. 

[NOTE]: Make sure the latch is down before reinserting the ink cartridges. If this latch is left in the raised position, the ink cartridges may not be properly positioned, causing problems during printing. For proper ink cartridge installation, the latch must remain in the down position

(7) Close the access door to the ink cartridges.

If your Print Head problem has not been resolved, try doing it again and again according to the above procedure.

Subscribe to receive free email updates:

0 Response to "How to Reinstall Print Head on HP Officejet Pro 8610 Printer? [Solution]"

Posting Komentar